Finance

ASTM C1036 PDF

Flat Glass Inspection Criteria per ASTM C – 11/ASTM C Terminology. crush:lightly pitted condition with a dull gray appearance. dig:deep, short. Find the most up-to-date version of ASTM C at Engineering This standard is issued under the fixed designation C ; the number ASTM Standards: 2 cut size, n—glass ordered cut to its final intended size.

Author: Malajind Shakara
Country: Maldives
Language: English (Spanish)
Genre: Literature
Published (Last): 28 August 2009
Pages: 177
PDF File Size: 8.66 Mb
ePub File Size: 12.44 Mb
ISBN: 728-3-37346-216-2
Downloads: 24295
Price: Free* [*Free Regsitration Required]
Uploader: Arashinos

ASTM C – 16 Standard Specification for Flat Glass

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

D For Q1 and Q2 only, the blemish size includes associated distortion see 6. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

Production of general use mirrors and other applications. None allowed None allowed Allowed Allowed with a minimum separation of mm 24 in.

  ENTERPRISE JMS PROGRAMMING BY SHAUN TERRY PDF

Discoloration and slight distortion of wire are permissible. Production of architectural glass products including coated, heat treated, laminated, and other select glass products. Two types of glasses shall be used: The allowable blemish sizes listed in Table 9 do not include associated distortion.

Allowable zstm for glass thicker than See Table 1 for acceptance criteria.

C Standard Specification for Flat Glass_百度文库

Glass Standards and Guidelines. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. As an alternate method, the thickness may be measured using two bars with? Point blemish, linear blemish content, associated distortion, dimension, squareness, reflectance and transmittance.

For linear dimensions of nonrectangular shapes, the length and width requirements in Table 2 shall c136 used. Allowed with a minimum separation of mm 48 in. F Allowed with a minimum separation of mm 24 in. For glass thicker than 6.

Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. Individual reprints single or multiple copies of asm standard may be obtained by contacting ASTM at the above address or at phonefaxor service astm.

  GEORGES BATAILLE BLUE OF NOON PDF

Allowable distortion for glass thicker than 6. Check with the manufacturer for thickness and dimensional tolerances on random Pattern P3 and special Pattern P4.

Flat Glass Inspection Criteria per ASTM C 1036 – 11/ASTM C 1048-12

Refer to Table 6 for evaluation criteria. Start with the glass sample parallel with the zebra board identi? The values given in parentheses are for information only. Cookies are small files stored in your browser and are used by most websites to improve your overall experience.

Check with the manufacturer for more information. The monolithic atm glass shall be supplied as cut sizes or stock sheets.

Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. F None allowed Allowed with a minimum separation of mm 24 in. Your comments will receive atsm consideration at a meeting of the responsible technical committee, which you may attend.

Heavy mm 6 in.